Falcon® Fixed Mount - 0 Degrees

A bracket that puts a Falcon flag on the leg of a canopy tent instead of on a base taking up floor space. It is a steel plate with a ball-bearing spindle welded to it: the bottom pole section drops onto the spindle, and the flag turns freely with the wind rather than loading the tent frame sideways.

The number in the name is the angle between the mounting plate and the spindle. At 0° the spindle runs in line with the plate, so the flag follows whatever the mounting surface does — the right choice on a leg that stands vertical. For a leg that splays outward, the 30° version kicks the pole back toward upright. If you are not sure which one your tent needs, send a photo of the leg to sales@dgcreativ.com and we will tell you which to order.

Specifications

• Type: fixed flag mount, steel
• Angle: 0° between plate and spindle
• Spindle: welded ball bearing, so the flag rotates
• Fits: square and hexagonal tent legs
• Included: mount only — no pole set, no graphic
• Use: outdoor

Shipping

Shipping on this item is quoted at checkout.

Frequently asked questions

Does this include the flag?
No. Mount only. The Falcon flags and the pole sets are listed separately.

0° or 30°?
0° for a vertical leg, 30° for one that leans. Photograph the leg and ask if it is a close call.

Can I put a flag on each leg?
Yes, with a mount per leg. On a 10 x 10 tent two is usually enough; four reads as a wall.

Will it mark the tent frame?
It clamps to the leg, so expect the same wear any clamp leaves. Mount it below the graphic line where it will not show.

Related: 30° mount for angled legs · 90° mount for walls and floors · Falcon feather flags · Custom printed canopy tents